Touch Dry    : 2 hours

  Hard Dry      : 8 hours

  Drying time above is based on temperature 28 - 32°C, humidity 70 - 80% and 5% dilution with Nippon General Purpose Thinner.

  8 hours

  Recoating time above is based on temperature 28 - 32°C, humidity 70 - 80% and 5% dilution with Nippon General Purpose Thinner. 

  *Important Note : 

Drying Time and recording time are strongly depending on environment ventilation, paint thickness, environment temperature, environement humidity, number of coats applied, thinner used to dilute product and recoat materials. So drying time and recoating time prvoided is for guide only. 

  2 COATS

  The paint is ready for use after thorough stirring. Dilute the paint with 5% - 10% of Nippon General Purpose Thinner, if necessary.

  Recommend to use Nippon Synthetic Brush or Nippon WB 4 Inch Roller for application

  9000 Aluminium Wood Primer  :  1 coat

Wood

Surface must be dry and free from dirt, grease and other contaminants. Smoothen surface with sandpaper and then clean off and dry. The scraped areas should be spot-primed using an undercoat for wood surfaces.

Metal

Surface must be dry and free from dirt, grease and other contaminants. Ferrous substrate should be sanded or wire-brushed to remove millscales and rust. Clean off dust and dry. The scraped areas should be spot-primed using a primer for metal.

• Keep container tightly closed and keep out of reach children or away from food and drink.
• Ensure good ventilation during application and drying.
• When applying paint, it is advisable to wear eye protection.
• In case of contact with eye, rinse with plenty of water immediately and seek medical advice.
• Remove splashes from skin by using soap or water.
• Paint must always be stored in a cool place.
• When transporting paint, care must be taken. Always keep container in a secure upright position.
• Dispose off any paint waste in accordance with the appropriate Environment Quality Regulations.

* Theoretical Coverage is based on a mathematical formula

and does not consider LOSS FACTORS.
Variables like porosity of substrate, application method, dilution ratio, dry film thickness, opacity and so on will affect the
loss factor and can vary from 30% - 50% or even more.
The above information is given to the best of our knowledge based on laboratory tests and practical experience.
However, since we cannot anticipate or control the many conditions under which our products may be used, we can only
guarantee the quality of the product itself.
We reserve the right to alter the given without prior notice.