Touch Dry    : 20 minutes (dependent on temperature and humidity)

  Hard Dry      : 1 hour (Dependent on temperature and humidity)

 10 - 12m² per litre per coat (Actual coverage is dependent and substrate condition, application method, application condition and finishing appearance.

  5100 Wall Sealer / Advance 8000 Wall Sealer / Expresskote Sealer / Acrylic 5170 Wall Sealer / Hi-Bond Wall Sealer (on powdery or skimcoated surface) : 1 coat

• Remove all loose, defective paint or powdery residues, loose chalk, dust, fungus, algae and foreign matter.
• Treat any areas affected by fungus growth with Fungicidal Wash Solution.
• Repair cracks, uneven surfaces with suitable exterior grade fillers.
• Smoothen the filler areas with sand paper. Surfaces to be painted must be cleaned thoroughly and dry, it must be free from dirt, grease and other foreign matters.
• Allow all surfaces to dry completely prior to painting.
• Avoid painting when the moisture content and alkalinity of the walls are still high. (Recommended painting specification requires the moisture content of the walls to be below 16% measured by protimeter and alkalinity of the walls to be below pH9.)
• Spot prime with Nippon Exterior Wall Sealer.

• Keep container tightly closed and keep out of reach children or away from food and drink.
• Ensure good ventilation during application and drying.
• When applying paint, it is advisable to wear eye protection.
• In case of contact with eye, rinse with plenty of water immediately and seek medical advice.
• Remove splashes from skin by using soap or water.
• Paint must always be stored in a cool place.
• When transporting paint, care must be taken. Always keep container in a secure upright position.
• Dispose off any paint waste in accordance with the appropriate Environment Quality Regulations.

* Theoretical Coverage is based on a mathematical formula

and does not consider LOSS FACTORS.
Variables like porosity of substrate, application method, dilution ratio, dry film thickness, opacity and so on will affect the
loss factor and can vary from 30% - 50% or even more.
The above information is given to the best of our knowledge based on laboratory tests and practical experience.
However, since we cannot anticipate or control the many conditions under which our products may be used, we can only
guarantee the quality of the product itself.
We reserve the right to alter the given without prior notice.