Touch Dry : 1 hour (Dependent on temperature and humidity)

Hard Dry : 4 hours (Dependent on temperature and humidity)

7 days

Drying time will become remarkably delay under low temperature. Over coating the previous coat should be done within 6 ~ 7 days but preferably as soon as possible after it has been allowed 8 hours drying or else, it is desirable to roughen it by dry sanding with sandpaper before it is over coated. This is to ensure proper intercoat adhesion. Exposure of the paint film to water, chemical and abrasion should be avoided as far as possible before full cure of the coating. When chalking occur, chalks should be removed by water washing. Allow the surface to dry thoroughly prior to over coating.

13.1 m2 per litre per coat (for dry film thickness of 35um)

11.5 m2 per litre per coat (for dry film thickness of 40um)

Tile Primer : 1 Coat

Surfaces should be clean, dry and free from oil, grease and contaminants before painting. For previously painted surfaces, remove all unstable paint film, loose chalk, dust and foreign matter. Repair any surface defects, clean off and dry. Avoid painting on the substrate with high moisture content. Avoid painting when the environment relative humidity exceeds 85%, or when the surface to be painted is less than 3°C above the dew point. For concrete floor, the surfaces should first be degreased using an appropriate solvent or detergent solution. then mechanically abraded. All laitance must be removed by mechanical abrasion or light abrasive blasting. New concrete must have cured or a minimum of 28 days..

Clean up equipment with water immediately after use.

* Theoretical Coverage is based on a mathematical formula

and does not consider LOSS FACTORS.
Variables like porosity of substrate, application method, dilution ratio, dry film thickness, opacity and so on will affect the
loss factor and can vary from 30% - 50% or even more.
The above information is given to the best of our knowledge based on laboratory tests and practical experience.
However, since we cannot anticipate or control the many conditions under which our products may be used, we can only
guarantee the quality of the product itself.
We reserve the right to alter the given without prior notice.