High Gloss / 

Soft Matt

  Touch Dry    : 30 minutes

  Hard Dry      : 1 hour

  Drying time above is based on temperature 28 – 32 °C, humidity 70 – 80%

  2-3 hours (minimum) 

  Recoating time above is based on temperature 28 – 32 °C, humidity 70 – 80% and 5%

*Important Note:

Drying Time and recoating time are strongly depending on environment ventilation, paint thickness, environment temperature, environment humidity, number of coats applied, thinner used to dilute product and recoat materials. So drying time and recoating time provided is for guide only.

 30 - 40 µm per coat (based on substrate condition)

 2 - 3 coats

Wood

Wood must be dry and free from dirt, grease and other contaminants. Smoothen surface with sand paper, then clean off and dry.

Metal

Surface must be dry and free from dirt, grease and other contaminants. Ferrous substrate should be sanded or wire-brushed to remove mill scales and rust. Clean off dust and dry. Scrap off any loose and flaking paint film. Sand and smoothen defective areas. The entire surface must be dry and free from dirt, grease and other contaminants. For the case of ferrous substrates, remove rust thoroughly. The scraped areas should be spot-primed. Light sanding on surface would ensure better subsequent intercoat adhesion.

• Keep container tightly closed and keep out of reach children or away from food and drink.
• Ensure good ventilation during application and drying.
• When applying paint, it is advisable to wear eye protection.
• In case of contact with eye, rinse with plenty of water immediately and seek medical advice.
• Remove splashes from skin by using soap or water.
• Paint must always be stored in a cool place.
• When transporting paint, care must be taken. Always keep container in a secure upright position.
• Dispose any paint waste in accordance with the appropriate Environment Quality Regulations.

* Theoretical Coverage is based on a mathematical formula

and does not consider LOSS FACTORS.
Variables like porosity of substrate, application method, dilution ratio, dry film thickness, opacity and so on will affect the
loss factor and can vary from 30% - 50% or even more.
The above information is given to the best of our knowledge based on laboratory tests and practical experience.
However, since we cannot anticipate or control the many conditions under which our products may be used, we can only
guarantee the quality of the product itself.
We reserve the right to alter the given without prior notice.